Thanks for the advice and all your help.
Here is the latest:
I connected the wires that link up the
T - stat, hi - limit and thermal cut-off -
Model SGDS800MQ0 (PART # 17)
I FINALLY get a glow on the igniter but no fire.
The following parts seem to be working properly:
Thermal fuse (NEW)
Thermostat (ordered but dont think I need it)
FLame sensor (NEW)
Coils (NEW)
Does the dryer need the thermal cut-off kit to start the flame or is there something else wrong? I know this isn't a good solution but since the wires are plastic covered I used my old thermal fuse (which appears to be fine) to jump the t-stat wires. Could direct hot wiring help?
I am ordering the Thermal cut off kit now but want to see what else it could be? lol after replacing every little part I am feeling pretty stupid about now.