View Single Post
  #14 (permalink)  
Old 12-17-2009, 02:46 PM
sarmoby sarmoby is offline
Junior Member
 
Join Date: Dec 2009
Posts: 3
sarmoby is on a distinguished road
Default I had an "A ha!" moment

Rich-
I just zoomed into the drive block photo and realized that the top of the Spin tube are supposed to go into those grooves ont he drive block. It appears that most of the grooves are ground off my drive block and are scattered around the machine seal and agitator. What oil should I put in to replace the missing oil in the spin tube shaft housing( only got a few drops out of it)?

The brake pads/ are tight on this unit as well so I will follow your sticky suggestions.

There appears to be no out-of-balance switch on this machine as it will bang on an un-balance.

Parts are on order from you folks so we will see what I can do with it.
thanks again
Scott
Reply With Quote
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17