Our dryer hasn't been drying for about a week now. I ran the diagnostic on the heating element and it doesn't turn on at all. I'm not convinced it's the heating element, so I then broke down the dishwasher to view the control board. On the back side of it, I noticed a small burn (soot-like) area at one of the solder points, maybe 1/2" in diameter. I'm guessing this is not good; I'm trying to determine if the board simply shorted out or if something else caused it.
Also, I just read this thread:
Heater Element Disconnected
The bottom of it does an excellent job of describing they symptons. Not drying, much longer cycle time, etc. I did have the recall work done on this about 4 months ago, but I'm sure it's been working fine up to the last week or so. Perhaps coincidental.
Thoughts? Thank you.