[capt]

I replaced a motor assembly (complete unit) on my dishwasher. The job went excellent thanks to your advise. I layed it on it's side and 45 minutes later job was complete. I now find I have low water level problem on start up, and it appears to drain slightly as it washes. If I cancel between rinse cycle via reset I do eventually get a correct water level. Any suggestions on parts to replace and it what order. My water hookup (valve) appears different from every thread I researched here. My float level appears to move up and down freely and I did replace the drain hose (cracked) after repair but didn't wrap it up around top side of unit as I direct line into my plumbing in basement.