View Single Post
  #4 (permalink)  
Old 01-04-2008, 03:45 AM
richappy richappy is offline
Senior Expert
APP Volunteer
Join Date: Sep 2007
Location: State College, Pa.
Posts: 9,586
richappy is a splendid one to behold

On your service sheet there is a chain diagram for no spin problems. It includes the door switch, the soap dispenser reed switch and the timer. Probably a bad door switch. There is an easy test for this.
Remove front panel and locate the test connector near the door switch. Stick your voltmeter leads in this, should not be any voltage during spin. Voltage=bad door switch.
If no connector, you will need to pull the door switch to check. I usually remove the right side of the boot to facilitate door switch removal. Get some super glue to re-attach boot.

Last edited by richappy : 01-04-2008 at 03:58 AM.
Reply With Quote

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17